Sales
E-mail :
+91 79977 49483, +91 83283 62632

Support

+91 9032063336/7 ( 9:00 AM to 6:00 PM IST || Mon - Fri )

How to increase entity selection pickbox size and entity snap aperture

progecad jytra advantages

Below are the steps to achieve this result in ProgeCAD 2014 Software.

  1. Select any entity inside progeCAD.
  2. In that condition, go to Tools->Drawing Settings -> Coordinate Input Tab
  3. Then you will notice two options at the bottom on Entity Selection Pickbox, increase the size at the pickbox dropdown list.
  4. Similarly you can increase the Entity Snap Aperture, by increasing the Aperture size.

Thank you for choosing ProgeCAD software, a read CAD alternative at very affordable cost.